1

Forty-eight 10/100/1000BASE-T ports

2

Four 10GE SFP+ ports

Applicable modules and cables:

· GE optical module

· GE-CWDM optical module

· GE-DWDM optical module

· GE copper module

· 10GE SFP+ optical module (OSXD22N00 not supported)

· 10GE-CWDM optical module

· 10GE-DWDM optical module (applicable in V200R009C00 and later versions)

· 1 m, 3 m, and 10 m SFP+ high-speed copper cables

· 5 m SFP+ high-speed copper cable (applicable in V200R009C00 and later versions)

· 3 m and 10 m AOC cables

· 0.5 m and 1.5 m SFP+ dedicated stack copper cables (used for zero-configuration stacking, supported in V200R011C10 and later versions)

3

One ETH management port

4

One mini USB port

5

One console port

6

One USB port

7

Ground screw

NOTE:

It is used with a ground cable.

8

ESN label

NOTE:

You can draw it out to view the ESN and MAC address of the switch.

9

Rear card slot 1

NOTE:

This slot is reserved for future use.

10

Rear card slot 2

NOTE:

Card supported: ES5D21X04S01 (4-Port 10 GE SFP+ Rear Interface Card)

11

Power module slot 2

NOTE:

Applicable power modules:

· 350 W DC power module

· 600 W AC power module

12

Power module slot 1

NOTE:

Applicable power modules:

· 350 W DC power module

· 600 W AC power module

Item

Description

Memory (RAM)

4 GB

Flash

512 MB in total. To view the available flash memory size, run the display version command.

Power supply surge protection

· Using AC power modules: ±6 kV in differential mode, ±6 kV in common mode

· Using DC power modules: ±1 kV in differential mode, ±2 kV in common mode

Dimensions (H x W x D)

44.4 mm x 442.0 mm x 420.0 mm (1.75 in. x 17.4 in. x 16.5 in.)

Weight (with packaging)

10 kg (22.05 lb)

Stack ports

Four fixed 10GE SFP+ ports on the front panel or ports on the 4-port 10GE SFP+ rear interface card

NOTE:

The switch supports service port stacking since V200R009C00.

RTC

Supported

RPS

Not supported

PoE

Not supported

Rated voltage range

100 V AC to 240 V AC, 50/60 Hz

-48 V DC to -60 V DC

Maximum voltage range

90 V AC to 264 V AC, 47 Hz to 63 Hz

-38.4 V DC to -72 V DC

Maximum power consumption (100% throughput, full speed of fans)

183.3 W

Typical power consumption (30% of traffic load)

· Tested according to ATIS standard

· EEE enabled

· No PoE power consumption

128.93 W

Operating temperature

0°C to 45°C (32°F to 113°F) at an altitude of 0-1800 m (0-5906 ft.)

NOTE:

When the altitude is 1800-5000 m (5906-16404 ft.), the highest operating temperature reduces by 1°C (1.8°F) every time the altitude increases by 220 m (722 ft.).

Short-term operating temperature

-5°C to +50°C (23°F to 122°F) at an altitude of 0-1800 m (0-5906 ft.)

NOTE:

When the altitude is 1800-5000 m (5906-16404 ft.), the highest operating temperature reduces by 1°C (1.8°F) every time the altitude increases by 220 m (722 ft.).

The equipment can operate beyond the normal operating temperature range for a short-term period, but the following conditions must be met:

· The equipment operates at a temperature of over 45°C (113°F) consecutively for at most 96 hours in one year.

· The equipment operates at a temperature of over 45°C (113°F) for a total of no more than 360 hours in one year.

· The equipment operates at a temperature of over 45°C (113°F) for no more in 15 times in one year.

The equipment may be damaged or experience unexpected exceptions if any of the preceding limits is exceeded.

The equipment cannot start when the temperature is lower than 0°C (32°F). The maximum distance of optical modules used in these conditions cannot exceed 10 km.

Part number

02358598